2001-08 Hummer H2 4WD Torsion Bar Leveling Kit Instructions
The net amount of ride height increase depends upon the age and use of the vehicle, wheel offset, and numerous other factors. Stated torsion bar ride height in- creases are based upon factory...
View Article06-09 Hummer H3 3,” 4″ and 4-1/2″ Cradle Mount Sidebar Installation Instructions
PROCEDURE: 1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. 2. Starting on the driver side of the vehicle, locate the two threaded...
View Article2003-2005 Hummer HII Edelbrock Lower Trailing Arms Installation Instructions
1. Raise vehicle and support with jackstands on a stable surface. Note: Vehicle must be supported with vehicle’s normal weight on rear axle. Do not support vehicle by its trailing arms. 2. Remove only...
View Article03-05 Hummer H2 P/N 200-183 Installation Instructions
Installation Instructions. Read Me! I) DISCONNECT NEGATIVE (-) BATTERY CABLE. II) Remove the Factory Air Box a) Loosen Mass Air Meter hose clamps and set meter aside. b) Unbolt the three air box hold...
View ArticleHummer H2 Powerstep Installation Instructions
Step One REMOVE CANISTER PURGE VALVE BRACKET AND ROCK RAIL Remove the Canister Purge Valve Bracket from the Rock Rail. Set the bolt aside to be reused later. Then remove the ten bolts that secure the...
View ArticleHummer H3 Rear Stabilizer Bar Installation Instructions
THIS ANTI-SWAY BAR IS DESIGNED TO REPLACE THE FACTORY INSTALLED REAR SWAY BAR AND UPGRADE THE FRONT SWAY BAR BUSHINGS. 1. Remove the factory installed rear anti-sway bar from factory mounts and end...
View ArticleHummer Air Valve Installation Instructions
To Install 1. Attach the CTI Line with the swivel nut to the air valve. 2. Remove the ―” X 20 Nyloc Nut from the Valve 3. Put the air valve in the valve hole and hold in place. 4. Place Stainless...
View Article2005-06 Hummer H3 3.5L Dynomax Kit:19425 Installation Instructions
NOTE: Read all instructions before starting any work. 1. Remove the O.E. front pipe/muffler/tail pipe assembly from the vehicle. Lubricate the rubber isolators with WD-40, or a similar lubricant, to...
View ArticleHummer H-2 Fuel Door NON LOCKING Installatio Instructions
1. Remove the OEM gas cap. 2. Remove the 3 mounting bolts from the filler neck. 3. Remove plastic gas shroud by turning counter clock wise and pulling up. 4. Attach the black latch using the 6-32 x...
View ArticleGobi Hummer Sut Rack Installation Instructions
The rack must be inspected before each use to make certain attachments are secure, and for evidence of Wear. Misuse of the rackor failure to observe the manufacit/rer ’s mär action s as to...
View Article